Getting Started with the OpenScope MZ

Despite our hopes and effort to create an innovative and low-cost T&M solution, we’ve received consistent negative feedback on the OpenScope MZ and OpenLogger regarding overall reliability that has led us to determine that it is not up to our high standards for our test and measurement products.

Unfortunately, we are unable to fix many of the issues, so we have made the difficult decision to pull both products, and related accessories from our shelves. This will allow us to ensure we can continue to deliver on the Digilent brand promise and focus our efforts on expanding our popular and core line of Test and Measurement Products.

The materials on this page will remain here as legacy sources. Any Digilent provided support for this material will be extremely limited at best. Thank you for understanding.

This document will walk you through the OpenScope MZ setup process. Please post any questions or comments in theWaveForms Live and OpenScope MZ forums

Setup the Digilent Agent and Connect to the OpenScope MZ(Required)

TheDigilent Agentis a service that runs in the system tray on Windows, Mac, or Linux and enables WaveForms Live to communicate with Digilent hardware. The Digilent Agent makes it easy to update the OpenScope MZ's firmware, configure Wifi and calibrate the instruments.

  1. Download and install the Digilent Agent.

WaveForms Live provides a browser-based instrumentation environment for managing devices and acquiring data. WaveForms Live uses the Digilent Agent to communicate with local devices via USB.

  1. Connect the OpenScope MZ to the computer via USB.
    • It may take the several seconds for the computer to recognize the device the first time it is connected. Subsequent connections will be established faster.
  2. Right click the Digilent Agent in the system tray and clickLaunch WaveForms Live.
    • This will launch waveformslive.com if you have internet access or a locally hosted version of WaveForms Live if not.
  3. Add the Digilent Agent and OpenScope MZ to WaveForms Live.

    • ClickAdd A Device.


    • ChooseAgent.


    • Enter thehostname or IP addressof the device where the Agent is running and clickAdd Device.
      Typically the default value “http://localhost:42135” is correct for an agent running on the local machine.



    • Select the COM port associated with the OpenScope MZ from the drop down.


Update the OpenScope MZ Firmware (Required)



  • ClickUpdate Firmwareand follow the instructions to update the firmware on the OpenScope MZ.


  • Review theCurrent Firmware Versionon the device and theLatest Firmware Versionavailable.
  • Select the desiredAvailable Firmware Version
  • ClickUpdate.
  • 固件更新大约需要10秒nd Waveforms Live reports the firmware update progress.
  • ClickDone. The firmware is now updated.
Calibrate the OpenScope MZ (Required)



  1. Under theCalibration节n clickCalibrate.



  2. Device specific instructions are provided.
    1. Connect the solid red wire to the solid orange wire.
    2. Connect the solid white wire to the solid blue wire.
    3. ClickNextto begin calibration.



  3. The calibration process takes about 30 seconds.



  4. The calibration information is displayed. Select the desiredstorage location(flash is recommended) and clickSave. Then clickDone.



  5. The new calibration data has been applied to the instrument and will be applied at boot.
Take A Measurement (Recommended)
  1. Click the newdevice cardto navigate to the instrument panel for the OpenScope MZ.


  2. Connect the solid orange wire (Osc Ch 1) to solid yellow wire (AWG Ch 1).

  3. Click the power button to turn on the WaveGen. This will generate a 1 KHz sine wave which can be read on oscilloscope channel 1.


  4. Click Single to acquire a single buffer of data.


  5. The data is displayed on the chart.


,,,,